Universal electronic Hour Count for motorcycle

Wireless hour meter - Maintenance and Timer System

A small but indispensable accessory, through which you can schedule maintenance and then know when to change the oil, filters engine, etc.. with accuracy by avoiding errors that might affect the operation of the engine.
It is a universal product and easy to install. The instrument can be fixed by a simple double-sided tape or 2 screws through the frame of the bike. The detection signal of the motor turned on, takes place by induction, simply by wrapping three times the supplied electric cable around the spark plug wire.
The hour meter Ufo Plast is a waterproof version, to test the off-road extreme!

• Installation: No Battery and wire Required
• Works: Works on trailers, motors, machinery, equipment
• Resettable: partial counter reset. Total hours can not be reset
• Sensitivity: Can be set to High or Low
• Lock Mode: prevent false recordings of run time during transport
• Service life: 5 years with normal use
• Resolution: 0.1 Hours
• Waterproof: Completely waterproof: IP68

User Manual

Install the counter, with adhesive strip in the back, in a position with vibration coming from the engine (in motorbikes the best part is the outer part of the chassis), but not too close to hot components (as exhaust). Please clean deeply surfaces before install the hour meter with outer temperatures exceeding 10°C. In order to avoid accidental detachments it is possible to use holes in the sides of hour meter using two tie wraps to fix the product to the vehicle. To check a proper installation, please switch on the engine and wait a few seconds (around 8 – 10 s). The display will switch on showing the working hours and the blinking dot.

1) NORMAL USE: Switch on the engine and wait a few seconds (around 8 – 10 s). The display turns on automatically, showing the working hours and the blinking dot.

2) SENSITIVITY SETTING: Push briefly S button: the display shows tot for 3-4 seconds, and after this, the total working hours value for around 8 seconds. During the visualization, push S button briefly: display shows Par for around 3 seconds, and after this, the partial working hours for around 8 seconds. During the visualization, push S button again:

A. Set to high sensitivity: when the display show HI, Release S button, display will auto-switch off after a few seconds, the vibration sensitivity is set to high

B. Set to low sensitivity: when the display show HI, push S button again, the display show Lo, display will auto-switch off after a few seconds, the vibration sensitivity is set to low.

3) TOTAL COUNTER VISUALIZATION: Push briefly S button: the display shows tot for 3-4 seconds, and after this, the total working hours value for around 8 seconds. At the end of this visualization the display will turn off automatically.

4) PARTIAL COUNTER VISUALIZATION: Push briefly S button: the display shows tot for 3-4 seconds,  and after this, the total working hours value for around 8 seconds.During the visualization, push S button briefly: display shows Par for around 3 seconds, and after this, the  partial working hours for around 8 seconds. At the end of this visualization the display will turn off automatically.

5) PARTIAL COUNTER RESET: Push briefly S button: the display shows tot for 3-4 seconds, and after this, the total working hours value for around 8 seconds. During the visualization, push S button briefly: display shows Par for around 3 seconds, and after this, the partial working hours for around 8 seconds.Keep pushing S button until you see “ - - - - ” blinking. Release S button: display will auto-switch off after a few seconds and the partial hours counter is resetted.

6) LOCK MODE: Briefly press the S button to display Total Working Hours tot. The display will show tot for 3 seconds. While tot is flashing, press and hold the S button for 8 seconds to enter Lock Mode Loc. Briefly press the S button again to exit Lock Mode Loc. Display will automatically turn off.